The characteristics of PM10 generation by subway operation such as acceleration, constant velocity, deceleration or stoppage were measured in real time to study its causes. For measurement positions, the lower center point on the front side of the Tc1-car was selected to observe the re- suspension caused by train draft, and behind the M2-car wheel and the T1-car wheel were selected observe the abrasion loss from friction generation during cabin operation. The measurement results showed that the PM10 generation is increased by train draft was 5.6% in the constant velocity section and 1.45% in the acceleration/deceleration sections. The increase by adhesiveness for cabin acceleration/deceleration was 9.6%, while the increase caused by friction from motor operation and steering was 5.1%. On the other hand, the amount of PM10 flowing into the station when a cabin was stopped at a station was 136% of normal condition and this might be the key reason of PM10 pollution in a subway tunnels since most pollution is accumulated there. Keywords : Operation condition, PM10, Subway tunnel, Source